![]() Now there are two major thinr to do : 1)invoke the viewport toolbar to select(if available) 1"=20' or to manually input the 240 value and enter the input so as to scale the drawing within that viewport properly or 2) on command line invoke Z>S> 1/240XP and enter to scale that same viewport. ![]() Since you show a scale of 1"=20', that scale factor is = 20*12/1=240. Then go to the layout mentioned above and highlight the viewport where the barscale is and scale that part of the drawing. If you scale it the scale factor will be 80*12/80 or 12. Its total length s/b 80'but it shows at 6'8". Imported survey drawings may include drafting instructions where changing the base angle might be desirable to properly orient the data.2334 eng- I checked out your drawing and I'll concentrate on the lower right hand drawing of layout "1 SITE PLAN".įirst back in model space your barscale is wrong. The default is 0 degrees (East) and a counter-clockwise direction. Under Base Angle, enter a value for the default 0 angle direction.If you want to measure angles clockwise instead of counterclockwise, select Clockwise. Under Angle, select an angle type and desired precision.Under Length, select a unit type and desired precision.With this setting disabled, it would remain one unit long (which would now be only one millimeter rather than one inch). For example, if an item that is one inch long were inserted into a drawing set to millimeters, this setting would scale the item to 25.4 mm in length when enabled. To scale objects that you insert into the current drawing from drawings with different drawing units, select Scale Objects Inserted from Other Drawings.Ĭlear this option to insert objects at their original size without scaling.For example, if you select Inches, each drawing unit equals one inch. ![]() The units that you select determine the unit of measurement that each unit in your drawing represents. Various imperial and metric units are available. Under Drawing Units, select the desired units. ![]() Specifying default units options for the current drawing ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |